What will affect the production of mobile pelletizing equipment?

Mobile pelletizing equipment can process various of waste biomass material into biofule pellets, but after a long period of use, there will be dust during the operation, at this time it is necessary to check the mobile pelletizing equipment, identify the causes of dust according to the actual operation situation. Now, let’s discuss it in depth.

• Most of the dust in the mobile pelletizing equipment is due to too much material we put in the equipment, resulted the motor of mobile pelletizing equipment can not be used properly. The solution is simple, open the shell of the equipment, then use a fine brush to clean those materials attached to the equipment. This will not only increase our work efficiency, but also increase our speed to use the mobile pelletizing equipment.
• The dust in the mobile pelletizing equipment may be due to the aging of the host system, the slow rotation of the host causes the frequency of the pellets to vary, some powders were out of the equipment directly from the outlet without being processed, it needs to replace a new host system.
• The dust in the mobile pellet plant may be due to the problem in the pelletizing system of the plant, there are hard impurities in the raw material, for example the small stone hurt the roller of pelletizing equipment, or the bearing of the pelletizing roller has a problem, there is an error during the operation of mobile pelletizing equipment, resulted the powder to be discharged directly from the outlet. The solution is also very simple, that is, open the shell of the mobile pelletizing equipment to check and then repair the fault, or replace parts.

Similar problems often occur when the mobile pelletizing equipment is put into use, how to identify problems, and then prevent similar problems from happening later? The most important thing is to take care of the mobile pelletizing equipment, which is the key to preventing all problems.

• The usual maintenance of mobile pelletizing equipment is an important requirement to ensure its operation power. As the core equipment in mobile pellet plant，the labor intensity is great during the operation, it will inevitably occur the wear of important components, therefore, in daily use, users must pay attention to the maintenance of mobile pelletizing equipment.
• The rotation speed of the spindle is within the limit, the higher the spindle speed, the higher the production power, but when the speed exceeds the allowable limit, the production will decrease. In the empty operation, if the spindle speed is very high, the oscillation frequency of roller and cutter is very high, the material is pressed for a very short time, it will cause some materials to be expelled without be pressed into pellets, causing obstruction of crushing cavity, reduce the production. When the spindle speed is very low, the swing frequency of the hammer is less, the crushing time of the material is very little, it will also reduce production.
• Operators who operate the mobile pelletizing equipment must undergo professional training, have a full understanding of the performance of the equipment, operate the mobile pelletizing equipment in accordance with the correct operating standards, can not only ensure the personal safety, but also ensure the production of mobile pellet plant.
• Diameter of crushing chamber is an important factor affecting the output of mobile pelletizing equipment, Reasonable crushing chamber diameter can promote the operation power of the equipment. Therefore, when we design the diameter of crushing chamber, we pay special attention to the diameter of crushing chamber, so that it can play a positive role in the production of mobile pelletizing equipment.
• Influence of raw material properties on production of mobile pelletizing equipment. For example, when the mobile pelletizing equipment.is used to process high moisture content materials, because of the great toughness of straw, it is hard to be broken, and after the damage, the water in the straw decreased, and there must be stickiness, the rate of discharge will drop, which will decrease the production of the mobile pelletizing equipment.