Do you really know about GEMCO pellet making machine?

GEMCO is a famous pellet making machine manufacturer in the world. Many people want to choose GEMCO pellet mill to start their pellet making business. But do you really know about our pellet mill? Today I will give you a detail introduce.

pellet mill

Structural description

Main body: the fuselage is an independent rectangular cylinder. The device is closed with the bearing seat and the powder hopper. The powder hopper extends to the machine in the body. Under it, it has a V shaped chassis, which is wide and flat on the ground. Therefore, it must be installed below, and it can be placed indoors at any time.
Pellet making device: The rotary drum lying below the bucket, and a bearing support, it through the rack drive, for reverse rotation, the end face of the front bearing cover is movable and disassembled, as long as a rotary wing nut, bearing cover and a rotating drum can be taken out and placed on the two ends of the roller are convex the square ring, embedded bearing indoor, so that you can make the powder and oil seep without bond plug.
Reducer: The worm gear is used to drive the speed ratio to 1:12. The oil in the case can be stored to ensure that the gear is well lubricated and no noise. The box can be observed with a view mirror, observe the operation and storage capacity, and the outer end of the worm wheel is equipped with an eccentric shaft to drive the rack to reciprocate.

Machine parts lubrication

The box part of the machine is equipped with oil meter, and all the oil should be refueling once before operation. It can be added in the way of temperature rise and operation of each bearing.
Worm gear box must be long-term storage of oil, the oil level for the worm all invasive oil, such as the frequent use of every March for new oil once, located at the bottom of the plug, you can put the oil.
Do not spill the oil out of the cup while the machine is refueling, not to flow around the machine and on the ground. Because oil is easy to pollute the material and affect the quality of the product.

Maintenance instructions

Check regularly the machine parts once a month to check whether the active part of worm gear, worm, bolt and bearing on the lubrication block is flexible and wear. It is found that defects should be repaired in time and not be forced to use.
The machine should be used in a dry and clean room. It should not contain acids in the atmosphere and other places with corrosive gas circulation to the body.
When the machine is finished or stopped, the rotary drum shall be taken out for cleaning and cleaning the remaining flour in the hopper, and then installed to prepare for the next use.
When the drum in the work place before and after the move, the M10 screw bearing soldier to the proper position just before the school. If the gear axis traverse, please adjust the bearing frame behind the M10 screw to the proper position, adjust the gap to the bearing sound, hand turn the pulley, proper tightness is appropriate, too tight or too loose can make the machine damaged may.
Disable such a long time, the machine body wipe clean, parts of the surface coated with anti rust oil, covered with cloth punta.

Installation instructions

This machine is a packing, unpacking after moving to proper use, can be used after the pad.
The device of electrical wiring: we should pay attention to the direction of rotation, and do not reverse it, because one end of the worm has plane ball bearing, the direction of force must be on the bearing, otherwise it will make the worm at the other end of the worm heat and affect the service life of the machine parts.